Once the washer door is closed the washer can begin operating.
Washer lid locks then unlocks.
Pause the machine by quickly pressing the start stop button once.
Push the start stop button to unlock the washer door during the spin cycle.
The lid lock latch switch does three things.
The reason the lid unlocks is due to the electronic control board not seeing the lid has actually locked so the control board turns the unit off.
If it opens you re all set.
Most washing machines come equipped with a lid switch.
Let the washer sit unplugged for about 10 minutes then try lifting the lid.
After a few seconds the washer will halt and you ll hear the door unlocking.
Models without precise fill only lock during the spin cycle.
However some washing machines come with a lid lock.
If i press fill while the lid is up the washer will fill just fine but as soon as i close the lid again it will just lock and unlock again.
Inspect the door lock for damage.
This switch is connected to a solenoid that completes a circuit allowing the machine to run only if the top is down.
Add any extra garments into the washing drum at this time if necessary.
Perform the lid lock test under manual test mode on page 9.
Main control cannot determine if lid lock is in a locked state.
To unlock the lid.
Perform the following checks if the washer does not lock or unlock.
Pausing the machine will allow you to open the lid.
110 26002012 washer when i push start the lid locks and it spins then it unlocks and does nothing.
Door lock motor and switch assembly.
If it still won t budge proceed to plan b.
Pausing the wash cycle is how it can be disabled.
If the door lock is defective the washer door will not latch properly.
The door lock secures the washer door shut during operation.
During the spin cycle pausing the washer does unlock the lid but you must wait until the basket has completely coasted down to a stop before the lid unlocks for safety reasons.
Check lid lock mechanism for obstruction or binding.
Ge washer keeps locking and unlocking i tried to start a load this morning but it just keeps locking and unlocking once i close the lid.
The following steps assume that this step was unsuccessful.
The lid lock is a default feature of your maytag front loading and top loading washer to prevent opening the appliance while the cleaning cycle is in progress.
This switch performs the same function but the lid must be locked in place for the machine to wash.
