If exposed a 1 1 16 6 point socket with long breaker bar will be required to remove it.
Water heater rod connection.
I drained my water heater 2.
The only other wire to connect is the wire that goes to the metal case of the water heater where there s a green screw.
A few newer plastic lined tanks have no anode rods to replace before you get started close the shutoff valve turn on the hot water at a faucet to relieve pressure and turn off the electricity or gas to the heater.
Anode rods hot water heater maintenance tools supplies powered and aluminum zinc anode rods at wholesale direct prices.
Hot water faucet near the tank to remove air from tank while filling.
Check that the water heater s power and water are turned off.
Once the water within the tank is below the t p valve unscrew the valve using a pair of channel locks.
The water heater only requires 2 hot 120 volt wires to heat water and function.
Allow the water to cool then drain the tank to a level that is lower than the t p valve.
But the anode rod is designed to attract all those corrosive agents and sacrifices itself so that your water heater tank doesn t corrode.
Your anode rod is a long skinny rod that sits inside the water heater and prevents your tank from corroding.
If you have a separate inlet for the anode rod but can t get the old one out or the connections are too corroded to install the new one you can always install the new on the hot water outlet.
If the new water heater is shorter and the old wires won t reach surface mount a 4 in.
Water heater anodes and parts.
Open a nearby hot water tap to allow the air to flow into the tank.
The rod may be under the water heater s sheet metal top or connected to the hot water outlet nipple.
I poured 3 hydrogen peroxide in the water heater tank.
I believe the center wire on the 3 prong outlet is a neutral wire and i ve read that using neutral for chassis ground is never a good idea.
The water heater is only 5 months old.
Removed the old anode rod.
It was a horrible mess.
Per 10 gals of heater size 4.
Since most water heaters use a standard 3 4 npt connection you simply need to choose the type of installation you have.
If hidden an easy solution would be to remove the nipple on the hot water side with a pipe wrench and install a nipple outlet anode rod.
Most gas or electric water heaters require a standard rod length of 44.
Installed this new anode rod.