Water Shut Off Valve Leaking At Stem

First shut off the water to the leaking water valve.

Water shut off valve leaking at stem.

Step by step instruction showing how to stop a shut off valve from leaking at the stem. Remove the old washer and slide on the new one. Multi turn shut off valves have a handle that when tightened forces a rubber gasket onto a seat in the middle of the valve that restricts water. Unscrew the handle the packing nut and the threaded valve stem photo 2.

The packing nut is responsible for making a watertight seal where the valve stem meets the water line. Next remove the handle from the stem and then loosen and remove the packing nut. You may need to shut off water to the entire house if there is no cut off for the line. 1 x research source open a faucet to relieve back pressure on water line.

Place a bucket or a thick towel on the floor under the leaky valve just in case some residual water leaks out during work. Locate and shut off water supply to the line that feeds the leaking valve. A water shut off valve leaking can make a mess and waste water. This valve usually is in the basement or a utility closet and it will be clearly labeled.

So if there is a leak at the valve stem it most likely means the valve is not shut off all the way. Turn on all the faucets and flush all the toilets associated with the main shutoff valve to empty the pipes of water. The first thing you should do to stop the leak is to tighten the packing nut. If the leak persists before replacing the entire valve try this.

Several considerations dictate which is the best water shut off valve for your needs including the size of the inlet diameter and outlet diameter as well as how the valve is operated. Replacing old graphite valve stem packing with new teflon seal. Turn off the water at the house s main shutoff then disassemble the problematic shutoff valve without disconnecting the valve from either the water supply line or the line leading to the toilet. To tighten the packing nut follow these directions.

Water shut off valves often leak at the handle or the stem after they. For instance a standard stop and waste valve has three other washers that can leak in addition to the washer that shuts the water off.