First make sure that you shut off the water that supplies the valve you re going to be working on.
Water shut off valve stuck on pipe.
Not knowing how to free stuck plumbing valves though can lead to broken valves pipes and fixtures leading to more expensive repairs.
The types of water shut off valves connect to supply lines in different ways often dictated by the material of the connecting pipe.
During emergencies such as a broken water pipe however it is absolutely essential that the water valve that supplies that particular plumbing fixture can be turned on and off reliably.
Attempt to loosen the valve by opening and closing it several times by turning its handle.
Cut the supply line with a pipe cutter leaving enough room between the escutcheon plate and the cut to allow installation of the valve fitting.
Pex supply lines can use shut off valves with barbed compression or push to connect ptc fittings.
Turn off the next valve up the line which may be the main water supply valve.
Shut off the circuit breakers to an electric water heater.
Then open a faucet on the lowest level of your house and another faucet on an upper level to drain the pipes.
Have you ever tried to turn off the water to a sink or a running toilet only to find that the valve is stuck in place.
If you have a gas water heater turn the knob to the pilot position.
Open the faucet to drain the line.
Clean and prep it s a good idea to shut off the water supply before you try to bully a valve into submission.
Deburr the pipe with a deburring tool.
Then give the ball valve a try by hand.
First you will need to turn off the water supply to your home at the main shutoff valve.
Water shut off valves tend to accumulate mineral residue and freeze.
Then disconnect the supply tube from the shutoff valve.
Of course you won t find out until you need to shut off the valve to make a repair on a pipe line sink or bathtub.
When cutting the supply line cut slowly and gently so.
When you find that you have a pvc ball valve that just doesn t want to budge try these three steps to loosen it.
This tip if followe.
Here is a video showing you how to handle a situation in which the water shut off valve or angle stop does not want to close or shut off.
How to loosen a stuck water valve.
This is usually caused by the rubber.
Place a bucket under the old valve.
Before you try to loosen a stuck valve with brute force consider following these three simple steps.
Shut off the water at the main shutoff valve.