Water Softener Regeneration Process

The valve or control valve is the brain of the softener unit since it gives the commands as to when the softener regeneration process will occur.

Water softener regeneration process.

During the regeneration process the flow of water is extended to flow back through the softener through the use of a water loop. Water softener regeneration process. It is not recommended to use water during a water softener regeneration as hard water will fill the water heater which could lead to buildup in the equipment. How often a water softener will regenerate or recharge is controlled by the valve of a water softener system.

A rinse cycle commences and the salty water washes the mineral deposits off the resin beads. Water softener regeneration cycle time is about two hours. This step takes about 10 minutes. But first let s discuss why regeneration occurs.

Other considerations depending on the size of your water softener a regeneration cycle typically takes about 30 to 60 minutes and uses anywhere from 40 to 60 gallons of water. During regeneration salty water from the brine tank flows up the fill tube and into the softener tank. A normally functioning water softener takes water from the utility hookup source and sends it through the various tanks ion exchanging processes before it reaches your home. Water softener regeneration is the process which the softener system removes the existence of calcium and magnesium as well as other minerals and dirt from the water.