However the issue can be caused by multiple factors.
Water softener salt tank full of water.
If your softener isn t fully draining during the regeneration cycle then your brine tank will eventually fill up with water until the safety float is engaged.
The salt water solution in your brine tank will become too diluted and your softener will not be able to regenerate properly.
Hi can you tell me how much water should be in a brine tank of a water rite softener under normal use now it is full of water all the time is this normal.
If this valve is set high more than enough water will cause the salt tank issues.
If this is your problem it s time to clean the tank.
If your water softener is full of water another potential solution is to change the kenmore water softener float setting.
Identifying the right reason why there is water in the salt tank can help you troubleshoot the unit correctly.
1 water softener problems water in salt tank.
Salt clog in the bottom of the tank.
The valve controls the water entry so just replace it to resolve this if the problem is with the float valve.
This usually happens due to a lack of overflow or clogging.
As a result your water will remain hard.
I think this will just melt all the salt in the tank all the time.
For optimum water softener performance you should be sure to keep your salt level above the water level which is usually about one quarter full but do not overfill it.
There will normally be a few gallons of water in the brine tank but this should never be more than 12 inches deep.
Problems of salt bridges.
It is recommended that you check on the salt levels in the brine tank at least every 3 to 4 weeks.
Salt tank is full of water if there is a problem in the valve.
Water rite 740 water softener has brine tank full of water what s the normal liquid level in the brine tank.
Perhaps the primary concern water softener users are facing is a salt tank full of water.
Now there are several stages to the water softening process but the two most important with respect to the flooding problem are fill which just fills the brine tank with water and brine which moves the salty water from the brine tank to the resin tank where the water softening happens.
There are horizontal slots in the brine well that allow water to flow in and out.
You should never fill your tank more than about a six inch from the top this can encourage salt bridging and does not benefit the system in any way.
The more regularly your system regenerates the more often you will need to check and add salt to the brine tank.
The water softener float valve controls the water levels in the brine tank.
