Run at least 3 tests and determine an average value.
Water temperature testing procedure.
Deliver samples to the lab the day of.
Mechanic pressurizes the system raising the pressure in the system gradually until the designated test pressure is achieved.
During the first set of tests three new sensors monitored the water level.
Subtract the water temperature from the peak temperature and record.
For a pumping well immerse the thermometer in a container with water flowing through until the temperature stabilises.
The air temperature was monitored using three thermocouples.
In the testing procedure two variables were monitored.
If you want to form a very rough idea of whether water is cold lukewarm or hot first hold your hand above the water.
October 12 2018 epa announces approval of alternative testing methods pdf 17 pp 362 k about pdf federal register action fact sheet contact us to ask a question provide feedback or report a problem.
When a glass thermometer is used and the testing point can be reached immerse the thermometer in the water until the liquid column in the thermometer stops moving approximately 1 minute or longer if necessary.
A druck ptx 1230 water level sensor was used for control purposes during testing.
Pour the water into the beaker and observe the increase in temperature of the mixture while stirring with the thermometer.
Some water heater experts recommend testing every six months.
Record the peak temperature which will occur in about 20 seconds.
Maintains this test pressure for 10 minutes before inspection.
The water level and the air temperature.
Slip the rubber band around the wrist so that the thermometer is not lost if it is accidentally dropped into the water.
Ensures that water used for the test is at not less than ambient temperature but in no case less than 70 f.
Procedure for measuring water temperature tie one end of a piece of string securely to the end of the thermometer and the other end to a rubber band.
Cool to 10 c 50 f for source water and groundwater samples recommended for drinking water as well but do not allow samples to freeze holding times holding times are generally very short 8 hours for source water samples 30 hours for drinking water samples 48 hours for coliphage samples.
Then if test is above.
For drinking water analyses performed by laboratory assistants the actual results will be visibly verified by a microbiologist.
Two sets of tests were performed.
Results are checked before reports are issued by the senior or supervising public health microbiologist.
If the water container is large enough dip one of.
If you feel heat radiate off of the water it is hot and may burn you.
If you feel no heat the water will either be room temperature or cold.
A keller 46w pressure transducer a beltech bts bubbler and a celesco pt1ma float.
More frequent testing can reduce the chance of a leak caused by mineral and corrosion buildup.
